 |
SQUARE
WAVE PULSER |
| Voltage
: 125/250 Volts (50 Ohms) |
| Fall-time & decay : 5ns |
| Rep
Rate : |
20
to 20,000Hz internal |
| Divisor for |
0 to 20,000Hz external |
|
| Pulse
width : 25ns to 1,000ns |
| Post-trigger
: External mode |
Pulser on RCPP or MUX with :
USPC3100MB, MBC & MBA
USPC3100MH, MHC & MHA
|
|
RECEIVER/AMPLIFIER |
|
|
Impedance : 50 Ohms |
| Bandwidth : |
0.35 to 30 MHz Analogue |
| |
0.35 to 24 MHz Digital |
|
| Gain
: 70dB adjustable (.1dB step) |
| Back-Echo
Calibration : ± 70dB |
| Input
Attenuator : 0, 15dB |
| Attenuator
: 0, 20dB |
| Dynamic
Range : 105dB |
| Mode
: Pulse-Echo/Transmission |
| Filters
: 0.5/1/2.25/5/10/15/WB MHz |
| Rejection
: 0 to 50 % |
| RF
Output : |
2.0Vpp
(50 Ohms) |
| |
1.5Vpp FSH |
|
|
DAC |
|
Triggers :
Initial Pulse/Interface echo/Artificial |
| Dynamic
Range :
70dB |
| Slope
: ±
40dB/µs |
| Segments
: 30 |
| Auto Slope Adjustment |
|
GATES |
| GATE IF
(yellow) |
| GATE 1
(red) & GATE 2
(blue) |
|
All Gates fully independent |
| Start
: 80ns to 655µs - 20ns step |
| Width
: 20ns to 655µs - 20ns step |
| Level
: 10% to 90% -1% step |
| Double threshold : Gate 1 & 2 |
Triggers
: not active / Initial Pulse / Interface / Artificial on Gate 1 & 2
Gate to Gate on Gate 2 only |
|
Flaw In-line |
| Flaw Alarm : Positive/Negative |
| Noise suppression : 0 to 30 violations |
| Flaw Mode : Max. or First Echo Peak |
| Amplitude on Gates 1 & 2 only |
|
TOF In-line |
|
|
TOF Alarms : Min. & Max. |
| Noise suppression : 0 to 30 violation |
TOF Mode
: first echo on Gate IF and
Max. or first echo on Gate 1 & 2 |
| Wall Thickness In-line |
WT not available with :
USPC3100MB, MBC & MBA
USPC3100MH, MHC & MHA |
| WT Alarms
: Min. & Max. |
| Noise
Suppression : 0 to 30 violations |
WT Mode : first echo on Gate IF and
Max. or first echo on Gate 1 & 2 |
| WT Coupling Quality |
| WT Coupling Alarm |
| WT
Data process (DSP) : Upper & lower
limits, Max deviaton, Filtering, averaging, etc |
| TOF/WT
Origins : Peak, Flank, Zero crossing |
| Gating
Mode : HW+,HW-,FW & RF with 2 symmetrical
gates |
|
A-SCAN DISPLAY |
|
| Mode : HW+,HW-, FW & RF |
| Gates : Yellow (IF), Red (G1) & Blue (G2) |
| DAC Curve : 0 % to 70 % FHS (0-70dB) |
| Delay : 0 to 655µs - 20ns step |
| Range : 1µs to 1.3ms - 20ns step |
| Trigger : Initial Pulse/Gate 1 Start/Gate 2 Start /Gate 1 Trigger/Gate 2 Trigger |
| Displayed Peak : Snapshot or Max Peak |
| Velocity : Interface or Material |
| A-Scan length : 100 to 512 points |
| Acquisition mode : Free running or external |
| Units : µs/mm/inch |
|
 |
|
EVALUATION |
| Converter : 200 MS/s, 10-bits |
| Amplitude Resolution : 1 % FSH |
| TOF/WT resolution : better than 1μm. |
|
MEMORY |
FIFO Memory of All PCI Boards : allow to
transfer Parameter settings, A-Scan Scope
Display, Amplitude & TOF & Alarms Read
Out,…at PC screen update frequency to DLL
RAM Memory.
High Capacity FIFO Options for :
> Very High Speed C-Scan Data Transfer with
USPC3100LC, MBC & MHC
> Very High Speed A&C-Scan Data Transfer
with USPC3100LA, MBA & MHA |
|
ANALOG
OUTPUTS |
Amplitude,
TOF/WT & Coupling quality
:
5 Volts Full Scale (8-bits)
Selectable Offset & Range
Update Rate : at Pulse Repetition
Rate |
|
GO/NO-GO
ALARM OUTPUTS |
Loss
of IF, Flaw detection, TOF/WT Min & Max and
Coupling
:
Pull-up to max 30 Volts
Up-date Rate : at Pulse Repetition
Rate |
|
IN/OUTPUT
TRIGGERS |
|
|
PRF Link : Master Internal |
| PRF
In : Slaved to PRF Link or External Trig. |
| START
In : USPC-MUX Synchr. |
| PRF
Out : MUX. Sequential Firing Trigger |
| START
Out : MUX. Cycle of Tests Trigger |
|
PC
CARD FEATURES |
|
|
Bus : PCI |
| Size
: 1/1 full size |
| TX,
RX, RF : SMB Connectors |
In/Outputs
: 26-Pin HE10 Connector :
8
Analogue outputs
9
Go/No-GO Alarm Outputs
5
Volts, Ground
Triggers : PRF Link/In/out, Start In/Out
Card Ready & Enable Acquisition Out |
Consumption
:
+12.V./ 0.5Amp.
+ 5.V./ 1.0Amp.
+3.3.V./ 1.5Amp.
-12.V./ 0.1Amp. |
| Operating
temperature : 0°- 50°C (32°-122°F) |
Multiple
Channel Operation :
Parallel Firing
Timed Firing (Post-trigger)
Sequential firing (MUX. 8Channels) |
|
SOFTWARE |
| DSP
: 2 very fast DSPs allowing real time Stand alone
running (Socomate Property) |
| Standard
API (LabVIEW™) : uspc.Exe + Source |
| API
Tutorial Software : Help! |
| Multiple Card control : up to 16 per PC |
|
SDK |
Drivers
for Windows
:
2000/NT/XP for All Boards |
DLL
with Help!
Active-X control with Help!
High Speed Data Acquisition :
- C-Scan with USPC3100LC/MBC/MHC
- A&C-Scan with USPC3100LA/MBA/MHA
- LabView Demo Software, *.Exe + Sources
- VB,VC, Delphi & Borland Examples
With *.Exe + Sources |
|
